A paint cup is not just a reservoir; its feed style must match the spray gun and coating. Gravity-feed guns use an upper cup and often suit small repairs. Suction-feed guns draw material from below, while pressure-feed systems can support larger, steady-volume jobs. Check the gun’s specified cup type and capacity before buying. For a door edge, a smaller cup can limit leftover coating; on a full panel, repeated refills may interrupt a wet edge. Small details matter.
Coating viscosity matters, too. Thick primer may feed poorly if the cup, fluid passage, and tip are mismatched. Follow the coating’s technical data sheet rather than thinning by guesswork.
U.S. EPA spray-finishing guidance reports transfer efficiencies of at least 65% for HVLP equipment, compared with roughly 25–40% for conventional spray equipment. This is not a cup-efficiency figure: cup compatibility helps maintain a consistent feed, but pressure, distance, and technique also affect results.
Check the lid seal and vent; a blocked vent can make the flow pulse. I still find volume estimates imperfect. A partly filled cup may seem safer, yet mixed coating can pass its usable life before the job ends. A small test helps. It costs a little time.